Price: Contact
Acrylic Patch Binder is a 100% acrylic emulsion that is mixed with portland cement and sand, producing a patch mix with superior flexural, adhesive and impact strength.
5 Gallon Pail, 30 Gallon Keg, 55 gallon Drum
One gallon will produce enough patch mix (when mixed with sand and cement) to fill .86 square yard (approximately 7.75 square feet) at 1/4” depth.
When used as a Crack Filler: One gallon will produce enough material to fill 75-150 lineal feet of crack, depending on depth and width of crack.
Pavement surface must be cleaned entirely of dust, dirt, debris and all loose materials. New asphalt and concrete surfaces must cure 30 days before application.
A power mixer (drill with mixing attachment or mortar mixer) is recommended. However, materials can be mixed by hand. For patching and filling depressions, use the following mix design (based on 100 lbs. of silica sand for ease of calculation):
Note: Thoroughly mix dry sand and cement together first before adding to Acrylic Patch Binder.
Apply patch mix with smooth sided screed or trowel. Be sure to feather edges on patches. Acrylic Patch Binder patching mix should be applied in multiple lifts to achieve desired depth in patches greater than 1/2”.
Mix thoroughly for only 2 to 4 minutes. DO NOT OVERMIX as this may cause excessive air entrainment and loss of strength.
Allow surface to harden completely before applying coatings or opening to foot or vehicle traffic.
Wash tools in water before material dries.
